slurry pump startup instructions
The chemical slurry pump for conveying solid particles, corrosive liquid slurry. Transmission medium temperature of -40 ℃ ~ 105 ℃, double seal cooling device can transport medium temperature below 300 ℃ high temperature medium. Widely used in petroleum, chemical, metallurgy, synthetic fibers, pharmaceutical, food, brewing, environmental protection, wastewater treatment and other industrial sectors, but also for industrial and mining enterprises and urban water supply and drainage purposes china slurry pump .
Instructions start:
1, to prepare the necessary wrenches and tools.
2, check the seal grease is injected into the oil cup.
3, Check the pump rotation direction is correct, is reversed, the steering error can make the impeller nut loose, so that the corrosion medium into the shaft neck corrosion, resulting in pump can not work, may also make the impeller nuts thrown out to cause accidents. Before starting the pump coupling cover must be good, to ensure safety in production.
4, the position of the pump is lower than the liquid level (flow backward situation), slurry pump before starting, to open the pipe valve, the pump filled with a liquid pump. If the mounting position above the surface (vacuum), the pump to prime the pump before start and exhaust, so that the pump and suction piping filled with liquid, drain the air pump.
5, the starter motor, the slurry slowly open the outlet valve, Alloy steel standard the pump working properly, and then open the valve to the desired extent.
Choose efficient slurry equipment, is the key of seizing the market opportunity. High head slurry pump in order to enable the design of more rational, more humane design, there are many problems that need attention.
Post time: Jul-13-2021